Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
1.1. The control panel
1.2. Alarm lamps
1.3. An arrangement of identification tablets
1.4. Radio receiver AM-UKV with electronic adjustment
1.5. The AM-UKV-RADIO TAPE RECORDER with electronic adjustment
1.6. The catalyst
1.7. Keys
1.8. An ignition switch and the ignition lock
1.9. The handle of management of a screen wiper and a windscreen washer
1.10. The combined switch distant and a passing light
1.11. Heating of back glass and lateral mirrors
1.12. Possible malfunctions
1.12.1. Start of the engine from the auxiliary battery
1.12.2. Wheel replacement
1.12.3. Detection of a place of a leak
1.12.4. Weekly checks
1.12.5. Check and restoration of level of a liquid of a hydrodrive of brakes
1.12.6. Replacement of lamps and safety locks
1.12.7. Recommended lubricants and liquids
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



1-12-2-zamena-kolesa.html

1.12.2. Wheel replacement

The wheel replacement procedure is identical to all cars.

Preparation

PERFORMANCE ORDER
1. At a wheel puncture immediately stop the car, considering traffic conditions.
2. Establish the car on an equal firm surface on sufficient removal from a lane.
3. If necessary include a signal of an emergency stop.
4. If there is a sign on an emergency stop establish it for the prevention of other drivers.
5. Put the car on a lay brake and include the first or a reverse gear (position Park in cars with automatic transmission).
6. Block a wheel диагонально opposite to the replaced.
7. In order to avoid jack immersing in soft soil substitute under it a board.

Wheel replacement procedure

PERFORMANCE ORDER
1. Get a jack. The jack is strengthened on the right side of a luggage carrier, under лючком.
2. The spare wheel and the tool are in a niche in a luggage compartment, under a decorative overlay. Turn on the holder, get a spare wheel, hook and remove a decorative cap.
3. Ослабьте nuts of fastening of a replaced wheel.
4. Establish a jack under the strengthened section of a threshold of a body, rotate the jack handle clockwise until the wheel will not appear raised over the earth. As the handle are used the holder of a wheel and mount for removal of a decorative cap.
5. Turn away a nut and remove a wheel.
6. Establish a spare wheel, turn and tighten fastening nuts. Check up an inhaling of nuts after car lowering.
7. Establish a decorative cap so that the wheel gate was opposite its cast image on a cap.

After wheel replacement

PERFORMANCE ORDER
1. Clean from under wheels колодки.
2. Put in a luggage carrier a jack and tools, observing correctness of placing.
3. Check up pressure in the tyre of the established wheel. If pressure low or at you is not present a manometre, that, moving on small speed, reach the nearest garage and pump up the tyre to normal pressure.
4. Immediately hand over the damaged wheel (or the tyre) in repair.


1.12.1. Start of the engine from the auxiliary battery

1.12.3. Detection of a place of a leak