Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
11.1. Specifications
11.2. A hydrodrive of brakes
11.3. Tubes and hoses
11.4. Колодки
11.5. A brake disk
11.6. Drums
11.7. A support of a forward brake
11.8. A support of a back brake
11.9. The wheel cylinder
11.10. The main cylinder
11.11. A brake pedal
11.12. The vacuum amplifier of brakes
11.13. The amplifier of brakes and the return valve
11.14. The lever of a manual brake
11.15. Cables of a manual brake
11.16. Adjustment of a manual brake
11.17. The switch of a signal of braking
11.18. The switch of a lamp of a manual brake
11.19. Antiblocking system
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



11-11-pedal-tormoza.html

11.11. A brake pedal


Measurement of height of a pedal

1. The switch of a signal of braking

2. A rug

3. A waterproofing layer

4, 6. An antinoise covering of a partition

5. A floor

7. A rug

8. A pusher

9. A counternut



D. Height of the pressed pedal

H. Height of the released pedal

Adjustment

PERFORMANCE ORDER
1. Measure distance from a pedal to a floor.
2. If necessary remove the bottom forward panel from outside the driver (cм. Subsection 13.26).
3. Remove an overlay in the field of feet of the driver, disconnect latches and remove a rug, having opened access to лючку in an antinoise covering of a floor.
4. Remove лючок and check up pedal height.
5. Compare to standard value.
6. If necessary adjust a pedal, having arrived as follows.
7. Turn away a counternut of a pusher and rotating a pusher establish the necessary height of a pedal.
8. Tighten a counternut with the set moment.
9. Check up a free wheeling of a pedal which is equal to moving of a pedal to sensation of a weakness in resistance to its course.
10. After отпускания pedals the braking signal should die away.
11. Otherwise replace the switch (the switch is strengthened on a pedal arm байонетным by connection and it is not regulated).
12. Start the engine and idling check up height of the pressed pedal.
13. If the height is less than norm brakes are faulty.
14. In this case replace a liquid in a hydrodrive and remove air.
15. If this measure does not give results check up a condition of the main thing and wheel cylinders.
16. Upon termination of establish all removed panels.

Removal

PERFORMANCE ORDER
1. Remove the bottom forward panel from outside the driver.
2. Расшплинтуйте also remove an axis, check up an axis condition.
3. Disconnect wires from the switch of a signal of braking.
4. Turn away four nuts of fastening of an arm of a pedal to a partition (the same nuts the vacuum amplifier fastens also).
5. Turn away the top bolt and remove a pedal with an arm.
6. The brake pedal is executed together with an arm and separately does not vary.

Installation

PERFORMANCE ORDER
1. The pedal is established upside-down.
2. Check up pedal adjustment.


11.10. The main cylinder

11.12. The vacuum amplifier of brakes