Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
11.1. Specifications
11.2. A hydrodrive of brakes
11.3. Tubes and hoses
11.4. Колодки
11.5. A brake disk
11.6. Drums
11.7. A support of a forward brake
11.8. A support of a back brake
11.9. The wheel cylinder
11.10. The main cylinder
11.11. A brake pedal
11.12. The vacuum amplifier of brakes
11.13. The amplifier of brakes and the return valve
11.14. The lever of a manual brake
11.15. Cables of a manual brake
11.16. Adjustment of a manual brake
11.17. The switch of a signal of braking
11.18. The switch of a lamp of a manual brake
11.19. Antiblocking system
12. Suspension brackets and a steering
13. A body
14. An electric equipment



11.12. The vacuum amplifier of brakes


1. Disconnect the battery from weight.
2. On carburettor engines the amplifier it is possible to remove without removing soaking up collector or the main cylinder.
3. On инжекторных engines for access to the amplifier it is necessary to remove soaking up collector.
4. On carburettor engines remove the air filter (cм. Subsection 6.1.2).
5. Disconnect wires from the gauge of pressure of the hydraulic booster, remove an arm of a hose of the hydraulic booster.
6. Remove the main cylinder from the vacuum amplifier.
7. Disconnect from the vacuum amplifier a hose.
8. Disconnect a pusher from a pedal and turn away four nuts of fastening of an arm to the amplifier.
9. Remove the amplifier from outside a motor compartment.

The prevention

Do not damage a carving of hairpins of the amplifier of brakes.


1. The amplifier is established upside-down.
2. Before installation check up выступание a pusher over a surface of the case of the amplifier.
3. On cars without ABS-system adjust position of a pusher of the main cylinder, having exposed the size And.
4. The collector and the main cylinder are established in conformity c by subsection 6.2.14 and subsection 11.10.
5. Upon termination of adjust a brake pedal.

11.11. A brake pedal

11.13. The amplifier of brakes and the return valve