Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
11.1. Specifications
11.2. A hydrodrive of brakes
11.3. Tubes and hoses
11.4. Колодки
11.5. A brake disk
11.6. Drums
11.7. A support of a forward brake
11.8. A support of a back brake
11.9. The wheel cylinder
11.10. The main cylinder
11.11. A brake pedal
11.12. The vacuum amplifier of brakes
11.13. The amplifier of brakes and the return valve
11.14. The lever of a manual brake
11.15. Cables of a manual brake
11.16. Adjustment of a manual brake
11.17. The switch of a signal of braking
11.18. The switch of a lamp of a manual brake
11.19. Antiblocking system
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



11-2-gidroprivod-tormozov.html

11.2. A hydrodrive of brakes

For effective work of brakes it is necessary to remove air from a hydrodrive.

At air removal it is forbidden to add the fulfilled liquid.

PERFORMANCE ORDER
1. At hit of the liquids different from recommended system it is necessary to wash out and replace all уплотнители.
2. Before air removal it is necessary to eliminate any infringement of tightness of a hydrodrive.
3. Establish the car on an equal surface, stop the engine and include a manual brake.
4. Remove caps and wipe absolutely all the union.
5. Uncover a tank, add a liquid to a mark the MOVE.
6. Leaky wrap a cover, considering that liquid level should be supported always above mark MIN.
7. In the absence of a special set of work on air removal it is necessary to carry out together.
8. At use of a special set be guided by the instruction applied on a set.
9. Irrespective of a way it is necessary to observe sequence of prorolling.
10. If the hydrodrive is depressurized partially it is possible to be limited to air removal only from the depressurized contour.
11. Sequence of prorolling of brakes: the back left, forward right, back right, forward left.
12. Prepare a transparent vessel and a hose.
13. Dress a hose on the union (at the left the arrow specifies an union cap).
14. Other end of a hose place in a vessel, having poured a few liquids.
15. Check up liquid level in a tank.
16. Ask the assistant to press some times a pedal of a brake and to keep.
17. Turn away the union on 1 turn. When the liquid will cease to follow wrap the union and ask the assistant to release a pedal.
18. Check up liquid level in a tank.
19. Repeat such cycle until then while air will not be removed from system to what absence of vials in a liquid following through a hose testifies. Between separate cycles maintain about 5 seconds
20. Establish a dustproof cap, wrap the union, remove a hose and dress a cap.
21. Repeat procedure on other wheels.
22. Check up liquid level in a tank.
23. Upon termination of prorolling the brake pedal should be "rigid".
24. Otherwise repeat procedure.
25. If after repetition of prorolling the pedal remains "soft" the reason is deterioration of cuffs of cylinders.


11.1. Specifications

11.3. Tubes and hoses