Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
11.1. Specifications
11.2. A hydrodrive of brakes
11.3. Tubes and hoses
11.4. Колодки
11.4.1. Колодки forward brakes
11.4.2. Колодки back brakes
11.4.3. Колодки back drum-type brakes
11.5. A brake disk
11.6. Drums
11.7. A support of a forward brake
11.8. A support of a back brake
11.9. The wheel cylinder
11.10. The main cylinder
11.11. A brake pedal
11.12. The vacuum amplifier of brakes
11.13. The amplifier of brakes and the return valve
11.14. The lever of a manual brake
11.15. Cables of a manual brake
11.16. Adjustment of a manual brake
11.17. The switch of a signal of braking
11.18. The switch of a lamp of a manual brake
11.19. Antiblocking system
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



11-4-3-kolodki-zadnikh-barabannykh-tormozov.html

11.4.3. Колодки back drum-type brakes

Replacement

PERFORMANCE ORDER
1. Remove drums.
2. Clear a board of a brake and drums.
3. Pay attention to an arrangement back and forward колодок, springs and a backlash regulator between колодками and drums.
4. Remove clamping springs колодок for what press a cap and turn on 90 .
5. Remove springs, caps and get pins from the back party of a board of a brake.
6. Cautiously submit on itself and remove колодки in gathering with a regulator and a cable of a manual brake.
7. Disconnect the top and bottom springs колодок.
8. If necessary tie with a wire the cylinder that there were no pistons if on the cylinder there are traces подтеканий replace or repair the cylinder.
9. Disconnect from a lobby колодки a regulator and a spring.
10. Disconnect a regulator and a spring from back колодки.
11. Remove the lever of a regulator from a lobby колодки.
12. Disconnect a cable of a manual brake from the lever.
13. Get a lock washer.
14. Remove an axis of the lever and remove the lever with back колодки.
15. Attach a lock washer the lever of a manual brake to new колодке.

The prevention

Levers of a drive of a manual brake for the left and right wheels differ.


16. Slightly grease with special greasing of a surface of contact of a board of a brake with колодками.
17. Establish колодку on a board and attach a cable of a manual brake to the lever, having preliminary convinced of correctness of orientation of a spring of the lever. Fix колодку, having established a pin, a spring and having turned a cap.
18. Be convinced that the top end face колодки has come into a groove at an end face of the piston acting from the cylinder.
19. Attach a regulator spring to the top part back колодки, having hooked on a spring from that party колодки which is turned to a board.
20. Dress on back колодку the bottom returnable spring, having hooked on a spring from that party колодки which is turned outside.
21. Establish a lobby колодку and hook on a regulator spring for a pin from the back party колодки. Dress on a lobby колодку the bottom returnable spring.
22. Truncate распорку колодок, rotating a gear nut.
23. Grease contact surfaces распорки, levers of a manual brake and a regulator with special greasing.
24. Establish a regulator, having rested against corresponding grooves in колодках.
25. Check up correctness of installation of a regulator.
26. Establish a lobby колодку in a place, fix a pin, a spring and having turned a cap. The top part колодки should come into a cylinder groove, and bottom – in an emphasis on a brake board.
27. Establish the regulator lever on back колодку so that the lever has entered into gearing with an axis and a gear nut.
28. Dress the top coupling spring. On the extended part hook for an aperture in the regulator lever, and short – for a pin on a lobby колодке.
29. Check up correctness of installation of all details.
30. Rotating a gear nut, reduce колодки so that it was possible to dress a drum.
31. Repeat the described actions with a brake of other wheel and dress drums.
32. Before departure check up work of brakes.


11.4.2. Колодки back brakes

11.5. A brake disk