Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
11.1. Specifications
11.2. A hydrodrive of brakes
11.3. Tubes and hoses
11.4. Колодки
11.5. A brake disk
11.6. Drums
11.7. A support of a forward brake
11.8. A support of a back brake
11.9. The wheel cylinder
11.10. The main cylinder
11.11. A brake pedal
11.12. The vacuum amplifier of brakes
11.13. The amplifier of brakes and the return valve
11.14. The lever of a manual brake
11.15. Cables of a manual brake
11.16. Adjustment of a manual brake
11.17. The switch of a signal of braking
11.18. The switch of a lamp of a manual brake
11.19. Antiblocking system
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



11-6-barabany.html

11.6. Drums

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and establish on supports.
2. Remove a wheel.
3. Release a manual brake.
4. If the drum does not give in to removal reduce колодки, having arrived as follows.
5. Get заглушку from an aperture in a brake board.
6. Insert a screw-driver into this aperture, then pass a screw-driver through an aperture in колодке against the stop in the lever of a manual brake. Slightly strike on a screw-driver to release the regulator mechanism then reduce колодки.
7. If the removed drum put adjusting labels is established.
8. Remove a drum from wheel hairpins.
9. If the drum nevertheless does not give in to removal displace it, in regular intervals wrapping bolts М8 in special carving apertures.

Check


The prevention

Drums vary only in steam and with the complete set колодок.


PERFORMANCE ORDER
1. Cautiously clear a drum of a dust and a dirt.
2. Check up presence on a drum of cracks and wear tracks (with special attention check up places about apertures under hairpins).
3. Check up a condition of an internal surface, in the presence of traces of deep development the drum is subject to replacement.
4. If on an internal surface of a drum the fillet caused by deterioration was formed, the drum is subject to replacement. The fillet formed owing to corrosion or dirt adjournment should leave a small skin.
5. Check up ovality of a drum, having measured diameter in two mutually perpendicular directions. Ovality is corrected проточкой if after processing diameter of a drum does not become less limiting.

Installation

PERFORMANCE ORDER
1. From a new drum remove preservative.
2. Reduce length распорки, having twisted a gear nut to establish a drum.
3. Establish a drum, having combined the put labels (if the removed drum is established).
4. Press some times a brake pedal.
5. Adjust a manual brake.
6. Establish a wheel, lower the car.
7. Before departure check up work of brakes.


11.5. A brake disk

11.7. A support of a forward brake