Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
11.1. Specifications
11.2. A hydrodrive of brakes
11.3. Tubes and hoses
11.4. Колодки
11.5. A brake disk
11.6. Drums
11.7. A support of a forward brake
11.8. A support of a back brake
11.9. The wheel cylinder
11.10. The main cylinder
11.11. A brake pedal
11.12. The vacuum amplifier of brakes
11.13. The amplifier of brakes and the return valve
11.14. The lever of a manual brake
11.15. Cables of a manual brake
11.16. Adjustment of a manual brake
11.17. The switch of a signal of braking
11.18. The switch of a lamp of a manual brake
11.19. Antiblocking system
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



11-9-kolesnyjj-cilindr.html

11.9. The wheel cylinder


Details of the wheel cylinder of drum-type brakes
1. A cover

2. A piston head

3. The piston

4. A piston cuff

5. The cylinder

6. The union for air removal

7. A cap

The union and bolts of the wheel cylinder

A.Bolty

B. The union


Removal

PERFORMANCE ORDER
1. Remove drums.
2. Remove колодки.
3. For decrease in losses of a liquid densely wrap a tank stopper, having laid a polyethylene film, or press hoses.
4. Clear bolts of fastening of the cylinder to a board of a brake and the union.
5. Turn away the union and muffle a tube and an aperture in the cylinder.
6. Turn away bolts and remove the cylinder.

Dismantling

PERFORMANCE ORDER
1. Clear from the cylinder a dust and a dirt, having wiped rags moistened in spirit.
2. Remove covers.
3. Put on cylinders identification labels.
4. Get pistons and a spring.
5. All уплотнители the cylinder are subject to obligatory replacement.
6. Check up a condition of the piston and an internal surface of the cylinder.
7. In the presence of defects on these details the cylinder in gathering replace.
8. Before assemblage carefully clear all details, pistons, a spring and cuffs grease with a brake liquid.
9. Put on cuffs pistons.
10. Cautiously enter into the cylinder the first piston, being guided on the labels put at dismantling.
11. Establish a spring and the second piston.
12. Put on covers the cylinder, having greased their edges with a brake liquid.

Installation

PERFORMANCE ORDER
1. The cylinder is established upside-down.
2. Remove air only from a hydrodrive of a brake of a wheel (if integrity of other contours was not broken).


11.8. A support of a back brake

11.10. The main cylinder