Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
12.1. Specifications
12.2. Bearings of naves of forward wheels
12.3. A rack of a forward suspension bracket
12.4. The bottom lever
12.5. A spherical support of the bottom lever
12.6. The stabilizer of cross-section stability of a forward suspension bracket
12.7. Bearings of back wheels
12.8. Details of a back suspension bracket
12.9. A wheel
12.10. The switch of ignition and the lock of blocking of a steering column
12.11. A steering column
12.12. The steering mechanism
12.13. Covers of steering transfer
12.14. A hydrodrive
12.15. The hydraulic booster pump
12.16. Tips of steering draught
13. A body
14. An electric equipment



12.4. The bottom lever


1. Lift a forward part of the car and establish on supports.
2. Remove a wheel.
3. Turn away a nut of fastening of draught of the stabilizer to the bottom lever of a suspension bracket.
4. Turn away two bolts (are specified by arrows) fastenings of a collar of the lever to a suspension bracket cross-beam, remove a collar.
5. Release a nut (it is specified by an arrow) lever axes.
6. Расшплинтуйте also turn away a nut of a spherical support of the lever.
7. Disconnect the lever from a rotary fist, выпрессовав a spherical support.
8. Turn away a nut of an axis of the lever, remove a washer.
9. Displace the lever downwards and disconnect from draught of the stabilizer, remove the plug and a washer.
10. Remove the lever from an axis and get from under the car.


1. Check up a condition of the lever and plugs, presence on these details of wear tracks, cracks and other damages.
2. Check up люфт a spherical support, freedom of rotation of a spherical finger in the case. Check up a condition of a rubber cover.
3. The lever represents not folding design and is replaced in gathering. Plugs and a spherical support are not subject to separate replacement.


The prevention

All fastenings of the lever are definitively tightened after removal of the car from a jack.

1. Dress the lever on an axis.
2. Attach draught of the stabilizer, preliminary having established a washer and the draught plug (the convex party the washer should be turned to the plug).
3. Dress a washer and wrap a new nut, without tightening.
4. Attach a spherical support to a fist, wrap a nut, without tightening.
5. Establish a collar of the bottom lever, wrap bolts.
6. Establish on draught of the stabilizer the bottom plug and a washer (the convex party the washer should be turned to the plug), wrap a new nut.
7. Establish a wheel and lower the car.
8. Release a manual brake, roll the car forward and back, shake a forward part.
9. Tighten all fastenings of the lever with the set moments, зашплинтуйте a support nut new шплинтом.
10. Upon termination of check up corners of installation of wheels.

12.3. A rack of a forward suspension bracket

12.5. A spherical support of the bottom lever