Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
12.1. Specifications
12.2. Bearings of naves of forward wheels
12.3. A rack of a forward suspension bracket
12.4. The bottom lever
12.5. A spherical support of the bottom lever
12.6. The stabilizer of cross-section stability of a forward suspension bracket
12.7. Bearings of back wheels
12.8. Details of a back suspension bracket
12.9. A wheel
12.10. The switch of ignition and the lock of blocking of a steering column
12.11. A steering column
12.12. The steering mechanism
12.13. Covers of steering transfer
12.14. A hydrodrive
12.15. The hydraulic booster pump
12.16. Tips of steering draught
13. A body
14. An electric equipment
 




6ac69956



12-6-stabilizator-poperechnojj-ustojjchivosti-perednejj-podveski.html

12.6. The stabilizer of cross-section stability of a forward suspension bracket

Cнятие

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Remove a wheel.
3. Turn away a nut of fastening of bent for to a stabilizer cross-beam (And – a nut of fastening of draught of the stabilizer to the bottom lever, In – a nut of fastening of bent for to a stabilizer cross-beam), remove a washer.
4. Repeat actions on the opposite termination of the stabilizer.
5. Turn away bolts (are specified by arrows) stabilizer collars.
6. Remove the stabilizer.

Installation

PERFORMANCE ORDER
1. If on rubber buffers damages replace buffers are found out, having established them so that the painted corbel on a stabilizer cross-beam has been turned to a buffer inside.
2. The stabilizer is established upside-down.
3. The groove under a bolt on a collar should be turned towards a back part of the car (the direction is specified by an arrow, 1 – the stabilizer, 2 – a label (the painted corbel)).
4. The hinge of draught of the stabilizer should be located on the centre of the arch described by draught at its displacement. In this position the hinge should be completely unloaded (at the left – wrong ориентациа, on the right – correct).
5. All nuts and bolts to tighten only after removal of the car from a jack and suspension bracket deposits.

DRAUGHT OF THE STABILIZER

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Remove a wheel.
3. Turn away a nut of fastening of bent for to a stabilizer cross-beam, remove a washer.
4. Turn away a nut of fastening of bent for to the suspension bracket lever, remove the plug and a washer.
5. Remove draught, plugs and washers.

Installation

PERFORMANCE ORDER
1. If necessary replace draught plugs.
2. Draught is established upside-down.
3. Replace draught nuts, establish a washer the convex party to the plug.
4. The hinge of draught of the stabilizer should be located on the centre of the arch described by draught its displacement.


12.5. A spherical support of the bottom lever

12.7. Bearings of back wheels