Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
12.1. Specifications
12.2. Bearings of naves of forward wheels
12.3. A rack of a forward suspension bracket
12.4. The bottom lever
12.5. A spherical support of the bottom lever
12.6. The stabilizer of cross-section stability of a forward suspension bracket
12.7. Bearings of back wheels
12.8. Details of a back suspension bracket
12.8.1. A rack of a back suspension bracket
12.8.2. Levers of a back suspension bracket
12.8.3. Bars
12.8.4. The nave case
12.8.5. The stabilizer of cross-section stability of a back suspension bracket
12.9. A wheel
12.10. The switch of ignition and the lock of blocking of a steering column
12.11. A steering column
12.12. The steering mechanism
12.13. Covers of steering transfer
12.14. A hydrodrive
12.15. The hydraulic booster pump
12.16. Tips of steering draught
13. A body
14. An electric equipment
 




6ac69956



12-8-4-korpus-stupicy.html

12.8.4. The nave case

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and establish on supports.
2. Remove a wheel.
3. On cars with back disk brakes remove a disk and a support, without disconnecting a hose.
4. On cars with back drum-type brakes remove колодки and disconnect from the cylinder a tube.
5. Turn away a bar nut on the case of a nave and remove a washer.
6. Turn away a nut of an axis of levers on the nave case.
7. Turn away a nut of racks and remove the nave case.

Check

PERFORMANCE ORDER
Check up a case condition, at detection of cracks and damages replace in gathering with the bearing.

Installation

PERFORMANCE ORDER
1. Put on the case of a nave a bar.
2. Wrap new nuts of a rack and tighten with the set moment.
3. Attach levers and screw axis nuts.
4. Put on a washer and screw a new nut of a bar.
5. On cars with back drum-type brakes establish колодки and attach a tube.
6. Remove air from a hydrodrive.
7. On cars with back disk brakes establish a disk and a support.
8. Establish a wheel and lower the car.
9. Roll the car forward and back, shake upwards – downwards.
10. Tighten nuts with the set moment.
11. Check up a convergence of back wheels.


12.8.3. Bars

12.8.5. The stabilizer of cross-section stability of a back suspension bracket