Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
12.1. Specifications
12.2. Bearings of naves of forward wheels
12.3. A rack of a forward suspension bracket
12.4. The bottom lever
12.5. A spherical support of the bottom lever
12.6. The stabilizer of cross-section stability of a forward suspension bracket
12.7. Bearings of back wheels
12.8. Details of a back suspension bracket
12.8.1. A rack of a back suspension bracket
12.8.2. Levers of a back suspension bracket
12.8.3. Bars
12.8.4. The nave case
12.8.5. The stabilizer of cross-section stability of a back suspension bracket
12.9. A wheel
12.10. The switch of ignition and the lock of blocking of a steering column
12.11. A steering column
12.12. The steering mechanism
12.13. Covers of steering transfer
12.14. A hydrodrive
12.15. The hydraulic booster pump
12.16. Tips of steering draught
13. A body
14. An electric equipment
 




6ac69956



12-8-5-stabilizator-poperechnojj-ustojjchivosti-zadnejj-podveski.html

12.8.5. The stabilizer of cross-section stability of a back suspension bracket

Removal

PERFORMANCE ORDER
1. Lift a back part of the car and establish on supports.
2. Remove a wheel.
3. Turn away a nut (are specified by an arrow) fastenings of bent for to a rack.
4. Turn away bolts of collars of fastening of the stabilizer to a body arm (are specified by arrows).
5. Remove a stabilizer cross-beam.

Check

PERFORMANCE ORDER
If necessary replace buffers, having established them so that cuts have been turned upwards.

Installation

PERFORMANCE ORDER
1. The stabilizer is established upside-down.
2. Cut under a bolt in a collar should be turned downwards. The hinge of draught of the stabilizer should be located on the centre of the arch described by draught at its displacement. In this position the hinge should be completely unloaded (And – a cut, B – a collar, C – the stabilizer, D – draught).
3. Nuts of the stabilizer and draught replace.

DRAUGHT OF THE STABILIZER

Removal and installation

PERFORMANCE ORDER
1. Lift a back part of the car and establish on supports.
2. Remove a wheel.
3. Turn away a nut of fastening of bent for to a stabilizer cross-beam.
4. Turn away a nut of fastening of bent for to a rack, remove draught.
5. Check up a condition of hinges of draught, if necessary replace.
6. Draught is established upside-down.
7. Replace draught nuts.
8. The hinge of draught of the stabilizer should be located on the centre of the arch described by draught its displacement. In this position the hinge should be completely unloaded.


12.8.4. The nave case

12.9. A wheel