Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
13.1. Specifications
13.2. Maintenance service
13.3. Small damages of a body
13.4. Large damages of a body
13.5. A forward bumper
13.6. A back bumper
13.7. A cowl
13.8. A cable of a drive of the lock of a cowl
13.9. The cowl lock
13.10. Doors
13.11. The internal panel of a door
13.12. The door lock, the switch of the lock and a handle detail
13.13. Glass of a door and стеклоподъемник
13.14. A cover of a luggage carrier (sedan)
13.15. A cover of a cargo compartment (a compartment and a hatchback)
13.16. The lock of a cover of a luggage carrier (sedan)
13.17. The lock of a cover of a cargo compartment and the handle
13.18. Details of the central lock
13.19. External glasses
13.20. A windscreen, back glass and stationary glasses
13.21. The hatch
13.22. Decorative overlays of a body
13.23. Seats
13.24. Panels of facing of salon
13.25. Average section of the forward panel
13.26. Details of forward facing of salon
14. An electric equipment

6ac69956 Водный велосипед продажа.
Заказать сайт там.
Посоветуйте аниме и еще.


13.10. Doors

Removal and installation

1. Disconnect the battery from weight.
2. Remove the internal panel of a door (subsection 13.11 see).
3. Disconnect all sockets, designate a line of conducting and get from скоб.
4. Cautiously extend conducting from door apertures, having got уплотнители.
5. Beat out an axis of the terminator of opening of a door.
6. Designate position of loops on a door.
7. Supporting a door, turn away bolts of loops and remove a door.
8. Check up a condition of loops, if necessary replace, having turned away bolts on a body.
9. A coupling guard.
10. The bottom bolts of fastening картера couplings to the block of cylinders.
11. The door is established upside-down on the put labels. Replace a terminator axis. If necessary adjust a door.


1. Cautiously close a door, check up backlashes between the next panels.
2. The door is regulated by moving to apertures of loops of a door and a body at the released bolts. After adjustment bolts tighten.
3. Check up door-lock adjustment, if necessary adjust clamp moving on a body rack at the released bolts which after adjustment tighten.

13.9. The cowl lock

13.11. The internal panel of a door