| Glass |
| 1. Remove the panel and the screen. |
| 2. Establish the handle стеклоподъемника (or attach a switch socket, connect the battery to weight). |
| 3. Lower glass so that the bolt of the holder of glass has appeared in an aperture of a skeleton of a door. |
|
4. Supporting glass, turn away bolts of fastening of glass to the holder (are specified by arrows). In cars with a compartment body there is an additional bolt of fastening of glass to a roller of a lobby directing. |
| 5. Get glass through an aperture. |
| 6. Glass is established upside-down. At installation watch that the sealant has not lagged behind. Before panel installation check up work стеклоподъемника. |
| Стеклоподъемник (a hatchback and a sedan) |
| 1. Disconnect glass from стеклоподъемника (see above). |
| 2. Lift glass and fix a tape or wedges, or get. |
| 3. Disconnect electric drive sockets (if it is provided). |
|
4. Turn away bolts of fastening of a manual drive стеклоподъемника (or the electric drive) (are specified by arrows). |
|
|
| 5. Turn on top (a photo at the left) and bottom (a photo on the right) regulator bolts стеклоподъемника and get a regulator through a window aperture. The electric drive with cables gets together with a regulator. Preliminary designate an arrangement of disconnected details. |
| 6. Стеклоподъемник in gathering with a regulator and a drive it is established upside-down. Before panel installation check up work стеклоподъемника. |
| Compartment |
| 1. Disconnect glass from стеклоподъемника. |
| 2. Disconnect electric drive sockets. |
| 3. Turn away electric drive bolts стеклоподъемника. |
| 4. Turn away bolts of both directing and remove стеклоподъемник in gathering. Preliminary designate an arrangement of disconnected details. |
| 5. Стеклоподъемник it is established upside-down. Before panel installation check up work стеклоподъемника. |
| Corner of a window of a back door – 5 дверный a hatchback |
| 1. Remove elevating section of glass. |
| 2. Turn away bolts and remove back directing, supporting a corner. |
| 3. Cautiously get a corner with a sealant. |
| 4. Remove from a corner a sealant. |
| 5. The corner is established upside-down. |
