Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
13.1. Specifications
13.2. Maintenance service
13.3. Small damages of a body
13.3.1. Elimination of small scratches on a body
13.3.2. Repair of dents of a body
13.3.3. Elimination of consequences of corrosion or cracks in body panels
13.3.4. Drawing of a first coat and body painting
13.3.5. Plastic elements
13.4. Large damages of a body
13.5. A forward bumper
13.6. A back bumper
13.7. A cowl
13.8. A cable of a drive of the lock of a cowl
13.9. The cowl lock
13.10. Doors
13.11. The internal panel of a door
13.12. The door lock, the switch of the lock and a handle detail
13.13. Glass of a door and стеклоподъемник
13.14. A cover of a luggage carrier (sedan)
13.15. A cover of a cargo compartment (a compartment and a hatchback)
13.16. The lock of a cover of a luggage carrier (sedan)
13.17. The lock of a cover of a cargo compartment and the handle
13.18. Details of the central lock
13.19. External glasses
13.20. A windscreen, back glass and stationary glasses
13.21. The hatch
13.22. Decorative overlays of a body
13.23. Seats
13.24. Panels of facing of salon
13.25. Average section of the forward panel
13.26. Details of forward facing of salon
14. An electric equipment



13.3.2. Repair of dents of a body

1. If on a body there is a deep dent, first of all, it is necessary for curving so that the surface has accepted almost initial form.
2. It is not meaningful to try to restore precisely initial form as metal in the damaged area has been stretched at blow, and it cannot give precisely initial form.
3. Is better to restore a surface so that depth of a dent did not exceed 3 mm.
4. In case a dent not deep, at all it is not necessary to try to curve it.
5. If there is an access to an underside of the deformed surface, its form can to try be restored with the help киянки with a soft head.
6. Thus put the wooden block to an obverse surface of a body to accumulate energy of blows and to prevent occurrence of cambers.

In case the dent is in area of a body with the closing panel on an inside or something else does this area inaccessible from the inside, it is necessary to apply the following method.

1. Drill some small apertures in metal in the pressed area – especially in the deepest part.
2. Then twirl long self-cut screws in apertures so that they densely kept in metal.
3. Now the dent can be curved, having pulled for heads of screws by means of flat-nose pliers.
4. Following step is removal of a paint from the damaged area, and also from area in several centimetres around with the help наждачной a nozzle or the wire brush established on a drill.
5. If you do not have these tools, it is possible to take advantage of an emery paper.
6. Finishing preparation for first coat drawing, scratch a surface of metal a screw-driver or a file corner, or drill small apertures in the damaged area.
7. It will provide good gearing of a first coat.
8. For repair end execute the operations described in subsection 13.3.4.

13.3.1. Elimination of small scratches on a body

13.3.3. Elimination of consequences of corrosion or cracks in body panels