Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
13.1. Specifications
13.2. Maintenance service
13.3. Small damages of a body
13.4. Large damages of a body
13.5. A forward bumper
13.6. A back bumper
13.7. A cowl
13.8. A cable of a drive of the lock of a cowl
13.9. The cowl lock
13.10. Doors
13.11. The internal panel of a door
13.12. The door lock, the switch of the lock and a handle detail
13.13. Glass of a door and стеклоподъемник
13.14. A cover of a luggage carrier (sedan)
13.15. A cover of a cargo compartment (a compartment and a hatchback)
13.16. The lock of a cover of a luggage carrier (sedan)
13.17. The lock of a cover of a cargo compartment and the handle
13.18. Details of the central lock
13.19. External glasses
13.20. A windscreen, back glass and stationary glasses
13.21. The hatch
13.22. Decorative overlays of a body
13.23. Seats
13.24. Panels of facing of salon
13.25. Average section of the forward panel
13.26. Details of forward facing of salon
14. An electric equipment
 




6ac69956



13-7-kapot.html

13.7. A cowl

Removal

PERFORMANCE ORDER
1. Open a cowl, designate position of loops on a cowl.
2. Release a hose стеклоомывателя from скоб, having disconnected from the union.
3. Turn away fastening bolts to loops and with the assistant remove a cowl.
4. Check up люфт axes in loops, if necessary turn away two bolts and replace loops.

Installation

PERFORMANCE ORDER
1. Establish a cowl combine with labels on loops and tighten bolts.
2. Attach a hose and lay in скобы.
3. Adjust a cowl.

Adjustment

PERFORMANCE ORDER
1. Close a cowl and check up backlashes with adjacent panels of a body. If necessary ослабьте bolts of loops also adjust cowl position, tighten bolts.
2. After cowl adjustment check up work of the lock and adjust. The lock latch should work when the cowl is below a wing edge on 1,0–1,5 mm. Release lock bolts, adjust position and tighten bolts.
3. If necessary adjust position of a forward edge of a cowl on height, rotating the rubber buffers screwed in a forward partition of a body.


13.6. A back bumper

13.8. A cable of a drive of the lock of a cowl