Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
14.1. Specifications
14.2. Detection of malfunctions
14.3. Safety locks and the relay
14.4. Switches
14.5. Lamps of external illumination
14.6. Lamps of internal illumination
14.7. Devices of external illumination
14.8. Adjustment of headlights
14.9. The panel of devices
14.10. A sound signal
14.11. A cable of a drive of a speedometer
14.12. The lever of brushes of a screen wiper
14.13. The electric drive of a cleaner of a windscreen
14.14. The electric drive of a cleaner of back glass
14.15. Details of screen wipers
14.16. A radio tape recorder
14.17. Dynamics
14.18. The aerial
14.19. Pillows of system of safety
14.20. Electric equipment schemes
 




6ac69956



14-7-pribory-naruzhnogo-osveshheniya.html

14.7. Devices of external illumination


The prevention

At removal of any light device disconnect the battery from weight.


Removal and installation

PERFORMANCE ORDER
Headlights (a sedan and a hatchback)
1. Remove a plafond of the index of turns.
2. Remove a forward lattice.
3. Disconnect sockets.
4. Turn away two lateral screws.
5. Turn on two back nuts.
6. Get a headlight.
7. Installation is carried out upside-down. Believe reliability of fastening of installation of the bottom hinge Believe adjustment of headlights (subsection 14.8 see).
Plafond of the forward index of turn
8. Subsection 14.5 (on a photo the socket of the forward index of turn is shown) see.
Plafond of the forward repeater of turn
9. Subsection 14.5 see.
Forward antifog headlights
10. Subsection 14.5 see.
Projector
11. Subsection 14.5 see.
The block of back lanterns
12. Remove the holder of lamps.
13. Turn away four nuts (a photo at the left), remove an arm (a photo on the right).
14. Get the block of back lanterns. The block fastens sticky hermetic.
15. Clear the block of lanterns and an edge of an aperture of a body of the hermetic rests.
16. Put hermetic on an edge of the block of lanterns.
17. Establish the block of lanterns upside-down.


14.6. Lamps of internal illumination

14.8. Adjustment of headlights