Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
2.1. Specifications
2.2. Service through each 15000 km or 6 months
2.2.1. Replacement of oil and the oil filter
2.2.2. Check of turns of idling and quality of a mix
2.2.3. Replacement of spark plugs by cars without neutralizer
2.2.4. Check of level of a liquid of a hydrodrive of brakes
2.2.5. Check of level of a liquid in the wheel hydraulic booster
2.2.6. Check of level of a liquid in automatic transmission
2.2.7. Check of leaks and a condition of hoses
2.2.8. Check of level of oil in a manual transmission
2.2.9. Condition check колодок forward and back brakes.
2.2.10. Check and adjustment of a manual brake
2.2.11. Check and adjustment of a drive of coupling
2.3. Service through each 30000 km or 12 months
2.4. Service through each 60000 km or 2 years
2.5. Service through each 60000 km or 12 months
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



2-2-6-proverka-urovnya-zhidkosti-v-avtomaticheskojj-transmissii.html

2.2.6. Check of level of a liquid in automatic transmission

PERFORMANCE ORDER
1. Make a short trip to warm up трансмиссионную a liquid to working temperature then establish the car on an equal platform. Level трансмиссионной liquids is checked щупом which is located in a forward part of a motor compartment, directly under the ignition distributor (the distributor is mounted in the left part of a head of cylinders).
2. Translate the engine in an idling mode, the selector lever put in position "Р" ("parking"). Get щуп from a branch pipe of a measuring instrument and wipe dry pure rags or a brown paper. Insert щуп into place against the stop into a branch pipe, then get щуп. Define level by position of a film of a liquid, having paid attention to two sets of marks of level on щупе. On the one hand щупа there are marks of the top and bottom level for a cold liquid (these marks are designated "cold" and are put in the form of cuts on an edge щупа). On these labels it is possible to define level at liquid temperature т 30 to 50 With. From an opposite side щупа there are top and bottom marks "hot", put in the form of hyphens on which liquid level is defined at temperature from 50 to 80 by S.Na of heated-up transmission level it is necessary to define on labels "hot".
3. To add a liquid in transmission (if necessary) follows through a measuring instrument branch pipe, having inserted a funnel with a thin metal grid not to spill a liquid and to exclude hit of extraneous impurity. To add a liquid it is necessary until then while level will not be established between the top and bottom labels щупа for a corresponding temperature range.

The prevention

Liquid level should be always below the top mark, superfluous refuelling is forbidden.


4. Upon termination of make a short trip that the liquid was in regular intervals distributed on internal volume of transmission, then again check up level and if necessary add a liquid.
5. Always support liquid level between the top and bottom marks for a corresponding temperature range. Falling of level below the bottom mark can become the reason of various malfunctions and even serious breakages of transmission.


2.2.5. Check of level of a liquid in the wheel hydraulic booster

2.2.7. Check of leaks and a condition of hoses