Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
3.1. The petrol engine in volume of 1,4 and 1,6 litres
3.1.1. Kinds of repair of the engine without dismantle from the car
3.1.2. Dismantle and engine major repairs
3.1.2.1. Specifications
3.1.2.2. Engine major repairs
3.1.2.3. Diagnostics of the engine by means of the vacuum gauge
3.1.2.4. The power unit from a manual transmission
3.1.2.5. The power unit with automatic transmission
3.1.2.6. A head of the block of cylinders
3.1.2.7. A head of cylinders and valves
3.1.2.8. Pistons and rods
3.1.2.9. Коленвал
3.1.2.10. The block of cylinders
3.1.2.11. Shatunno-piston group
3.1.2.12. Radical and шатунные bearings
3.1.2.13. Piston rings
3.1.2.14. Start-up of the engine after major repairs
3.2. The petrol engine in volume of 2,0 litres
3.3. The diesel engine
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



3-1-2-8-porshni-i-shatuny.html

3.1.2.8. Pistons and rods

Removal

PERFORMANCE ORDER
1. Remove chains, a head of cylinders and the oil pallet.
2. If in the top part of cylinders the fillet it should be removed development or шабером was formed, without having damaged thus a cylinder wall. Fillet formation specifies in the strengthened deterioration of the cylinder.
3. On a rod and on a rod cover cylinder number (it is specified by arrows) which the given rod concerns should be stamped. Cylinder N1 is from outside a forward cover. If numbers are not visible, put their paint or накерните. Labels to put on прошлифованной to a lateral surface of a rod and a cover.
4. Establish pistons of 1st and 4th cylinder in position НМТ.
5. Turn away a nut шатунной covers of a rod of 1st cylinder. Uncover and get bottom шатунный the loose leaf. If the loose leaf is established again paste its sticky tape to the removed cover.
6. Stick with a tape of a carving of bolts шатунной covers.
7. The hammer handle push the piston in the cylinder and get the piston through the top part of the block of cylinders. Remove top шатунный the loose leaf and paste its sticky tape to the removed rod.
8. Put a cover on a rod and fix nuts, without breaking a former assembly order of details.
9. Having repeated the specified operations, remove a rod with the piston of 4th cylinder.
10. Similarly get rods with pistons from 2nd and 3rd cylinder.


3.1.2.7. A head of cylinders and valves

3.1.2.9. Коленвал