Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
3.1. The petrol engine in volume of 1,4 and 1,6 litres
3.2. The petrol engine in volume of 2,0 litres
3.2.1. Kinds of repair of the engine without dismantle from the car
3.2.2. Dismantle and engine major repairs
3.2.2.1. Engine major repairs
3.2.2.2. Dismantle of the power unit
3.2.2.3. The power unit from a manual transmission
3.2.2.4. The power unit with automatic transmission
3.2.2.5. A head of the block of cylinders
3.2.2.6. A head of cylinders and valves
3.2.2.7. The piston in gathering with a rod
3.2.2.8. Коленвал
3.2.2.9. The block of cylinders and коленвал
3.2.2.10. Shatunno-piston group
3.2.2.11. Radical and шатунные bearings
3.2.2.12. Piston rings
3.2.2.13. Start-up of the engine after major repairs
3.3. The diesel engine
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



3-2-2-13-pusk-dvigatelya-posle-kapitalnogo-remonta.html

3.2.2.13. Start-up of the engine after major repairs

PERFORMANCE ORDER
1. After the termination of assemblage of the engine check up level of oil and cooling liquid twice. Check up correctness of connection of conducting and hoses, remove from a motor compartment all extraneous subjects.
2. Disconnect wires of spark plugs, turn out candles and disconnect ignition, having got a high-voltage wire from a cover of the distributor and reliably having connected it to the block of cylinders a crosspiece with clips.
3. Turn коленвал a starter to погасания a control lamp of emergency pressure of oil. Screw candles and put into place high-voltage wires of candles and a distributor wire (subsection 2.2.3 see).
4. Start the engine. The engine should be started after the short time interval necessary for filling by gasoline of a fuel highway.
5. In process of an engine warming up watch closely occurrence of leaks of oil, gasoline or a cooling liquid. Occurrence of unusual smells and a smoke from the details which are exposed to influence of a heat, because of burning out of the rests of oil is supposed.
6. If yet the top hose of a radiator then stop the engine everything is all right wait does not heat up and check up levels of oil and cooling liquid.
7. Check up installation of ignition and idling adjustment (if check is provided), then stop the engine.
8. After some minutes check up level of oil and cooling liquid (subsection 2.2.8 see), if necessary restore.
9. If bolts of a head of cylinders are tightened according to the present description at the first start-up of the engine after major repairs to tighten head bolts it is not necessary.
10. If new pistons, rings, radical and шатунные bearings the engine should pass обкатку throughout the first 800 km of run have been established. During the period обкатки driving with completely open throttle заслонкой or with too small speed on any transfer is not supposed. It is recommended after обкатки to replace oil and the filter.


3.2.2.12. Piston rings

3.3. The diesel engine