Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
3.1. The petrol engine in volume of 1,4 and 1,6 litres
3.2. The petrol engine in volume of 2,0 litres
3.3. The diesel engine
3.3.1. Technical characteristics
3.3.2. A gear belt
3.3.3. Replacement of a lining of a head of cylinders
3.3.4. Valves
3.3.5. Replacement маслоотражательных caps of a core of the valve
3.3.6. Check of directing valves
3.3.7. Grinding in of a saddle of the valve
3.3.8. Processing of a head of cylinders / of valves
3.3.9. Check / adjustment of backlashes of valves
3.3.10. Compression check
3.3.11. A klinovyj belt
3.3.12. Malfunctions of the engine
3.3.13. System of greasing of the engine
3.3.14. Oil a contour
3.3.15. Removal and pallet installation картера
3.3.16. The oil pump
3.3.17. Cooling system
3.3.18. The injection device
3.3.19. Spark plugs
3.3.20. The power supply system
3.3.21. Check / replacement of the valve of a stopping delivery of fuel
3.3.22. Number of turns of idling and the maximum number of turns
3.3.23. Atomizers
3.3.24. The beginning of giving of the fuel pump of a high pressure
3.3.25. Operation during the winter period
3.3.26. Specifications of the power supply system of a diesel engine
3.3.27. A good advice for owners of the diesel car
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment



3.3.4. Valves


1. Remove a head of cylinders.
2. Remove a cam-shaft.

The prevention

If old details of their distributive mechanism are established it is necessary to establish on old places. Not to mix a detail, it is recommended to prepare a special place for an apportion of details.

3. Take out тарельчатые pushers and spread out them according to adjusting position.
4. Remove springs of valves. For removal of conic crackers and at the same time valves from springs use special отжиматель springs of valves.
5. Compress springs of valves and take out conic crackers.
6. Ослабьте also remove отжиматель valves.
7. Take out the valve.
8. Take out the top plate of springs, springs and the bottom plates of springs.
9. Remove маслоотражательные caps of cores of valves.


1. If are established old the valve and an old head of cylinders, before assemblage check up directing valves.
2. If new valves are established in an old head, it is necessary to process saddles of valves in a head of cylinders and to make grinding in of valves.
3. Clear valves of the rests of a deposit with the help шабера and a wire brush.
4. Grease all тарельчатые pushers with engine oil and insert into corresponding apertures.
5. Establish равпредвал.
6. Replace a lining of a head of cylinders, establish a head of cylinders.
7. If it is required, adjust a backlash of valves.

3.3.3. Replacement of a lining of a head of cylinders

3.3.5. Replacement маслоотражательных caps of a core of the valve