Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
3.1. The petrol engine in volume of 1,4 and 1,6 litres
3.2. The petrol engine in volume of 2,0 litres
3.3. The diesel engine
3.3.1. Technical characteristics
3.3.2. A gear belt
3.3.3. Replacement of a lining of a head of cylinders
3.3.4. Valves
3.3.5. Replacement маслоотражательных caps of a core of the valve
3.3.6. Check of directing valves
3.3.7. Grinding in of a saddle of the valve
3.3.8. Processing of a head of cylinders / of valves
3.3.9. Check / adjustment of backlashes of valves
3.3.10. Compression check
3.3.11. A klinovyj belt
3.3.12. Malfunctions of the engine
3.3.13. System of greasing of the engine
3.3.14. Oil a contour
3.3.15. Removal and pallet installation картера
3.3.16. The oil pump
3.3.17. Cooling system
3.3.18. The injection device
3.3.19. Spark plugs
3.3.20. The power supply system
3.3.21. Check / replacement of the valve of a stopping delivery of fuel
3.3.22. Number of turns of idling and the maximum number of turns
3.3.23. Atomizers
3.3.24. The beginning of giving of the fuel pump of a high pressure
3.3.25. Operation during the winter period
3.3.26. Specifications of the power supply system of a diesel engine
3.3.27. A good advice for owners of the diesel car
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment



3.3.6. Check of directing valves

At repair work on a head of cylinders with leaky valves it is not enough to process or replace valves and saddles. Besides it is necessary to check up deterioration of directing valves. Check for engines with the big run is especially important. The worn out directing do not guarantee the central landing of valves and lead to the big expense of oil. If deterioration is too great, directing valves it is necessary to replace (is carried out in a workshop).

1. Remove the valve.
2. Clear directing the valve a cylindrical brush.
3. Enter the valve in directing from outside chambers of combustion and measure люфт moving the valve here and there. Люфт the valve it is necessary to measure in parallel corresponding коромыслу since in this direction the greatest deterioration is shown.
4. For check put a steel ruler. Practically there should be no backlash. Boundary value: 0,2 mm.
5. If there is a micrometer and нутрометр, it is possible to measure an actual backlash between directing and a valve core.
6. If necessary replace directing (it is carried out in a workshop).

The prevention

At all do not establish again directing the same diameter.

Directing the valve
Demanded value
0,02 – 0,05 mm
0,10 mm
0,04 – 0,07 mm
0,10 mm

3.3.5. Replacement маслоотражательных caps of a core of the valve

3.3.7. Grinding in of a saddle of the valve