Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
6.1. Carburettor engines
6.2. Engines with system of injection of fuel
6.2.1. Specifications
6.2.2. The air filter
6.2.3. A cable of a drive throttle заслонки
6.2.4. A pedal of management throttle заслонкой
6.2.5. Fuel
6.2.6. System of injection of fuel
6.2.7. Декомпрессия fuel system
6.2.8. The fuel pump
6.2.9. The gauge of level of fuel
6.2.10. A fuel tank
6.2.11. System of injection of fuel
6.2.12. The case throttle заслонки
6.2.13. Units of system of injection of fuel The fuel and atomizer distributor A pressure regulator The gauge throttle заслонки Перепускной the air valve A measuring instrument of speed of a stream The valve of correction of idling at loading change on the engine The thermostat of the raised turns of idling The gauge of an angle of rotation коленвала and the transistor module The gauge of temperature of a cooling liquid The processor block The switch of neutral position of a check point The switch of a starter and a signal of movement by a backing The relay of the fuel pump and the management block The switch of correction of idling at hydraulic booster work The switch of correction of idling at conditioner work The gauge of speed of the car
6.2.14. A soaking up collector
6.2.15. A final collector
6.2.16. An exhaust system
6.3. System of a food / of release of the fulfilled gases
6.4. System of decrease in toxicity of the fulfilled gases
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment


6-2-13-4-perepusknojj-vozdushnyjj-klapan.html Перепускной the air valve

The valve is mounted in a forward part of the case заслонки.

Removal and installation

1. Disconnect the battery from weight.
2. Disconnect from the valve a socket (1 – a socket, 2 – fastening screws).
3. Turn away screws and remove the valve with a lining.
4. Disassemble the valve and check up freedom of moving of the piston.
5. If the piston заедает the valve replace.
6. Installation is carried out upside-down. The gauge throttle заслонки A measuring instrument of speed of a stream