Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
6.1. Carburettor engines
6.2. Engines with system of injection of fuel
6.3. System of a food / of release of the fulfilled gases
6.3.1. Models with one-dot electronic injection of fuel Technical characteristics The air filter An accelerator rope An accelerator pedal The gasoline which is not containing тетраэтилсвинца System of injection of fuel Fuel system The fuel pump The gauge of level of fuel A fuel tank The case throttle заслонки System of injection of fuel / of ignition Elements of system of injection of fuel A fuel injector A regulator of pressure of fuel The additional valve of giving of air A potentiometer throttle заслонки The gauge of a stream of air The electromagnetic valve of fast work of the engine The temperature valve of the accelerated warming up of the engine Демпфер throttle заслонки The gauge of an angle of rotation of a cranked shaft The capacity transistor The gauge of temperature of a cooling liquid The gauge of detonation combustion of fuel The electronic block of management of the engine A heater of a fuel mix The switch of neutral transfer The switch of blocking of a starter / of lanterns of a backing The relay of the electronic block of management of the engine, heating of a fuel mix and the fuel pump The switch in system of the hydraulic booster of a steering The switch in air central air An inlet collector
6.3.2. Models with multidot electronic injection of fuel
6.4. System of decrease in toxicity of the fulfilled gases
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment


6-3-1-13-4-potenciometr-drosselnojj-zaslonki.html A potentiometer throttle заслонки

The potentiometer throttle заслонки is established on the right party of the case throttle заслонки.

Removal and installation

1. Before its removal, disconnect a wire of the negative plug of the accumulator.
2. Access to a regulator of pressure of fuel will be essentially improved if to remove the air filter (subsection see).
3. Disconnect a socket of connection of a potentiometer throttle заслонки.
4. By means of a white paint or a marker make marks in the case throttle заслонки and a potentiometer.
5. Turn off and remove two fixing screws, then remove a fixing plate and a potentiometer.
6. At installation, establish a potentiometer on the case throttle заслонки so that its lever has been correctly established from above the lever of an axis throttle заслонки.
7. Establish a fixing plate, then, combine the marks made before removal, and twirl fixing screws a little.
8. Adjust a potentiometer. For this purpose by means of a tester established on measurement of resistance, check up, that resistance of a potentiometer was such as it is specified in subsection
9. If it is necessary, turn off fixing screws and turn a potentiometer.
10. When the potentiometer will be correctly established, reliably tighten fixing screws and connect a connection socket.
11. Connect the accumulator and if it is necessary, establish into place the air filter. The additional valve of giving of air The gauge of a stream of air