6-3-2-11-1-toplivnyjj-kollektor-i-toplivnye-inzhektory.html
6.3.2.11.1. A fuel collector and fuel injectors
The prevention Look safety measures in subsection 6.3.2 before the work beginning.
If you consider that the injector has failed, try to clear it by means of corresponding means for clearing of injectors, such, as Holts Redex Injector Treatment.
Hose of giving of fuel and hose of the return pipeline of a fuel collector – models with the engine in volume of 1,6 l
|
The hose of giving of fuel and hose of the return pipeline of a fuel collector – are specified by arrows. |
Removal
PERFORMANCE ORDER |
1. Disconnect a wire of the negative plug of the accumulator. For access improvement to a fuel collector remove a casing of the air filter, being guided by the instructions resulted in subsection 6.3.2.2. |
2. Disconnect a vacuum tube from a pressure regulator in fuel system. |
3. Let out pressure from fuel system, being guided by the instructions resulted in subsection 6.3.2.6. Then, release fixing clips and disconnect a hose of giving of fuel and a hose of the return pipeline on the left side of a fuel collector (fig. the Hose of giving of fuel and a hose of the return pipeline of a fuel collector – models with the engine in volume 1,6 see). Mark hoses, if it is necessary not to mix them at installation. |
4. Compress uvulas and disconnect sockets of connection from four injectors. |
5. Turn off and remove fixing bolts of a fuel collector, then, accurately remove a fuel collector and injectors from an inlet collector and get it from an impellent compartment. Remove the linings established between a fuel collector and an inlet collector, and remove consolidations of injectors from an inlet collector. |
6. Turn off two fixing bolts and remove a fixing plate from a corresponding injector. Squeeze out an injector and remove sealing rings. In the same way remove other injectors. |
7. Will throw out consolidations and sealing rings; at installation it is necessary to use the new. |
|
Installation
PERFORMANCE ORDER |
1. Installation is spent upside-down removals. Establish new sealing rings on those injectors which acted in film, and also, establish new consolidations of injectors on an inlet collector.
|
2. Grease with engine oil sealing rings for simplification of installation, then, establish injectors on a fuel collector; |
3. Establish new consolidation on each of injectors and establish a fuel collector on an inlet collector. |
4. Establish linings between a fuel collector and an inlet collector, then, in a diagonal order, since the middle, tighten fixing bolts till the demanded moment of an inhaling of a stage 1 (subsection 6.3.2.1 see). Then, again, in the same order tighten bolts till the demanded moment of an inhaling of a stage 2. |
5. On termination of installation start the engine and check up, whether there is no fuel leak. |
|
|
|