Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
6.1. Carburettor engines
6.2. Engines with system of injection of fuel
6.3. System of a food / of release of the fulfilled gases
6.3.1. Models with one-dot electronic injection of fuel
6.3.2. Models with multidot electronic injection of fuel
6.3.2.1. Technical characteristics
6.3.2.2. The air filter
6.3.2.3. An accelerator rope
6.3.2.4. An accelerator pedal
6.3.2.5. System of injection of fuel
6.3.2.6. Fuel system
6.3.2.7. The fuel pump
6.3.2.8. The gauge of level of fuel
6.3.2.9. A fuel tank
6.3.2.10. The case throttle заслонки
6.3.2.11. Elements of system of injection of fuel (engines in volume 1,6)
6.3.2.12. Elements of system of injection of fuel (engines in volume 2,0)
6.3.2.13. An inlet collector
6.4. System of decrease in toxicity of the fulfilled gases
7. System of start-up of the engine
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



6-3-2-3-trosik-akseleratora.html

6.3.2.3. An accelerator rope

Removal

PERFORMANCE ORDER
1. On models with the engine in volume of 1,6 litres remove a casing of the air filter (cм. Subsection 6.3.2.2) for access improvement by the end of the rope connected to the case throttle заслонки.
2. Unhook a cable from a cam on the case throttle заслонки.
3. Turn away a nut of a cover of a cable to an arm and get a cover of a cable from an arm.
4. Release a cable on all line of packing.
5. In salon remove the bottom panel from outside the driver.
6. Disconnect a cable from a pedal.
7. Turn away a nut of fastening of a cover to a partition of a motor compartment and get a cable, having stretched in a motor compartment.

Installation

PERFORMANCE ORDER
1. Pass a cable through a partition of a motor compartment.
2. Stretch a cable in a motor compartment and lay in a place.
3. Fix nuts a cable cover on a partition of a motor compartment.
4. Attach a cable to a pedal.
5. Establish the bottom panel.
6. Fix a cable cover on all line.
7. Attach a cable to a cam on an axis throttle заслонки.
8. Adjust a cable. On models "Phase II" with the engine in volume of 2,0 litres throttle заслонка copes through an intermediate cam which is established from above inlet коллекторa. Then adjust installation of a cam throttle заслонки.

Adjustment of a cam throttle заслонки

PERFORMANCE ORDER
1. Turn off a counternut and unscrew the restrictive screw of an intermediate cam.
2. Keeping a cam in position at which throttle заслонка it is completely open, twirl the screw so that it has concerned the restrictive lever. Then, release a cam and turn the screw on three complete revolutions clockwise. Keeping the screw, twirl a counternut.
3. Take away a cam in position at which throttle заслонка it is completely open, and check up, that the restrictive lever of a cam concerned the screw.


6.3.2.2. The air filter

6.3.2.4. An accelerator pedal