Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
7.1. Specifications
7.2. The battery
7.3. The generator
7.4. System of start-up of the engine
7.5. The gauge of emergency pressure of oil
7.6. A starter
7.7. Ignition system
7.7.1. Specifications
7.7.2. Check of system of ignition
7.7.3. The ignition coil
7.7.4. The ignition distributor
7.7.5. The integrated module
7.7.6. The module of the transistor switchboard
7.7.7. The ignition moment
8. Coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



7-7-7-moment-zazhiganiya.html

7.7.7. The ignition moment

Check and ignition installation are carried out by a stroboscope.

On a pulley wreath there are the adjusting risks put with an interval in 5 . The first risk is located in 20 to ВМТ, and last – in 5 after ВМТ. The risk, corresponding ВМТ, it is noted by a yellow paint. The arrow notes the index on a forward cover.

Check and installation

PERFORMANCE ORDER
1. Warm up the engine, check up idling turns, switch off ignition.
Carburettor engines
2. Disconnect a hose from a vacuum regulator (or a hose of the gauge of a pressure on engines with neutralizer), a hose muffle.
3. Connect a stroboscope according to the instruction of the manufacturer.
4. Start the engine and direct light on a pulley коленвала. Idling shined label should be opposite to the index.
5. In need of adjustment release bolts of the distributor and turn the case of the distributor before combination of a label with the index.
6. Tighten bolts and again check up ignition installation.
7. Check up work of a centrifugal regulator for what be convinced that at increase of turns of the engine the scale on a pulley wreath is as though displaced "forward" concerning the index, and at decrease in turns to idling the shined label should be again opposite to the index.
8. Attach hoses and be convinced that ignition became earlier and the advancing corner corresponds to norm.
9. Otherwise the vacuum regulator (or the gauge of pressure of a pressure) is faulty or there is a leak in a hose.
10. Stop the engine and disconnect a stroboscope.
Inzhektornye engines
11. Disconnect a socket from the gauge заслонки.
12. Check up and adjust ignition (subitem 3-5 see).
13. Stop the engine and disconnect a stroboscope.
14. Attach a socket to the gauge throttle заслонки.


7.7.6. The module of the transistor switchboard

8. Coupling