Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
8.1. Specifications
8.2. Coupling adjustment
8.3. A coupling cable
8.4. A coupling pedal
8.5. Coupling
8.6. The mechanism of deenergizing of coupling
9. Transmissions
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



8-5-sceplenie.html

8.5. Coupling

Removal

PERFORMANCE ORDER
1. Remove a check point (subsection 9.1 see).
2. Designate coupling position on a flywheel.
3. Gradually turn away bolts in a cross order.
4. Remove coupling, having paid attention to position of a frictional disk.

Check


The prevention

It is recommended to change all coupling in gathering with выжимным the bearing even if separate details are subject to replacement only.


PERFORMANCE ORDER
1. Cautiously clear coupling, having wiped a liquid on spirit to a basis.
2. Check up deterioration of frictional overlays.
3. If the distance from a surface of a frictional overlay to heads of rivets is less or equally 0,3 mm frictional overlays replace.
4. Replacement of overlays also is required in case of detection on them of traces of oil, signs of deformation, cracks of traces проскальзывания.
5. Check up a condition шлицов naves of a frictional disk, springs, integrity of rivets.
6. If on a frictional disk oil traces before installation of a new disk find the reason are found out and eliminate.
7. Check up a condition of a press disk, check up durability клепки, having shaken a disk.
8. If overheat traces (a bluish shade) or ослабла диафрагменная a spring are visible, coupling replace.
9. Check up a condition шлифованных surfaces of a press disk and a flywheel.
10. Minor defects прошлифуйте, at strong damages of a detail replace.
11. Check up a condition выжимного the bearing, at the slightest defects replace.

Installation

PERFORMANCE ORDER
1. Carefully clear flywheel and coupling surfaces.
2. Establish a frictional disk so that the nave has been turned from a flywheel.
3. Keeping a frictional disk, put a coupling basket in gathering on adjusting pins, having combined the put labels.
4. Tighten bolts by hand.
5. Centre a frictional disk.
6. The disk can be centered, rotating пруток in a nave, resting against an aperture of a flywheel or by means of special оправки.
7. In regular intervals, in stages, tighten bolts of fastening of coupling with the set moment.
8. Grease шлицы a shaft of a check point and a plug axis with a thin layer of refractory greasing.
9. Establish a check point.


8.4. A coupling pedal

8.6. The mechanism of deenergizing of coupling