Service Nissan Sunny with 1991 on 1997 of release in a body n-14.
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Cooling system
5. Heating and ventilation system
6. Fuel and an exhaust system
7. System of start-up of the engine
8. Coupling
9. Transmissions
9.1. A mechanical transmission
9.2. An automatic transmission
9.2.1. Specifications
9.2.2. A cable of management of transmission
9.2.3. The selector
9.2.4. A switching cable for the lowered speed
9.2.5. A speedometer reducer
9.2.6. Epiploons
9.2.7. The double switch of a backing and starter blocking
9.2.8. The overload switch
10. Semiaxes
11. Brakes
12. Suspension brackets and a steering
13. A body
14. An electric equipment
 




6ac69956



9-2-2-tros-upravleniya-transmissiejj.html

9.2.2. A cable of management of transmission


Cable of management of transmission
1. The selector
2. Cable fastening to a floor
3. A floor
4. A cable
5. An arm
6. An arm
7. A nut of a cover of a cable
8. The transmission lever

Cable adjustment

1. The lever

2. A cable

3. A nut

4. The blocking switch of a starter

The arrow specifies an effort direction at adjustment.

Adjustment

PERFORMANCE ORDER
1. Translate the selector in River position
2. Lift a forward part of the car and establish on supports.
3. Be convinced that the transmission lever too is in River position
4. Turn away a nut of fastening of a cable to the lever.
5. Pull a dynamometer for an eye of a tip of a cable with force 0,7 кГс.
6. Remove a dynamometer and displace a cable back on 1,0 mm.
7. Keeping a cable cover, tighten a counternut.
8. Check up freedom of moving of the selector.
9. If at moving of the selector the cable is bent, repeat adjustment.
10. Grease rubbing surfaces of a cable and the lever and lower the car.

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports.
2. Translate the selector in River position
3. Remove the central section of the forward panel.
4. Turn away a nut, get скобу covers of a cable and disconnect a cable from the selector.
5. Turn away a bolt and remove an arm, extend a cable.
6. Turn away a nut on the lever, get скобу from an arm and remove a cable. Keep in mind that lever position on transmission at cable installation should not to change (designate lever position before cable removal).
7. Check up presence on a cable of wear tracks and damages.
8. Check up freedom of moving of a cable in a cover. Keep in mind that at installation into place the cable can заедать, despite seeming ease of its moving in completely straightened condition.
9. At strong damages a cable replace.

Installation

PERFORMANCE ORDER
1. Pass a cable through a floor and tighten fastening bolts to a floor.
2. Attach a cable to the selector and insert a cable cover into an arm.
3. Tighten a nut and insert скобу.
4. Translate the selector in position Р, be convinced that the transmission lever too is in River position
5. Put on a cable the transmission lever.
6. Fix a cable cover скобами.
7. Adjust a cable.
8. Establish the central section of the forward panel, lower the car.


9.2.1. Specifications

9.2.3. The selector